Imation DataGuard T5R User Manual download pdf (Page 10)

Figure 1

Figure 2

Follow the instructions below to install or replace hard disk drives, connect

the DataGuard Appliance to the network, and power it on. If your DataGuard

Appliance shipped with hard drives already installed, use these instructions

for replacing a hard drive.

UNLOCK AND OPEN SECURITY DOOR (T5R ONLY)

Using the key included, unlock the security door and open it completely.

REMOVE DRIVE CARRIER

1. Press the square button on the right side of a drive carrier. If you have

an R4 unit, removal of the front bezel is necessary to access the installed

drive carriers. This will release the latch on the left side. Hold the latch and

gently pull the carrier out of its slot. “If this is a drive replacement, remove

the four counter-sink screws as shown in the next section. It is now ready

to receive a new drive

Release Button

Drive Carrier Latch

PLACE NEW DRIVE IN CARRIER

1. Place the empty drive carrier on a table or other stable platform.

Orient the drive so that the SATA contacts and power connector

will face the rear of the enclosure (Figure 1). Place the drive in the

carrier so that the screw holes are aligned.

2. Fasten the drive to the carrier using only the counter-sink screws

provided (Figure 2). Use four screws per drive and be careful not

to over-tighten them.

✓

INSTALLING HARDWARE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 84 85

No comments

Imation DataGuard T5R User Manual Page 10